NAVGUARD/EE777A SETTING AND OPERATION GUIDE
 
 

HANGAR PROTECTION: (Fig. 1, 2)

  1. Mount the unit between 8 - 10 ft above the ground
  2. Pick up a mounting spot for protection coverage (back-wall or side-wall setting)
  3. Keep 6 - 8 ft from the hangar sliding door
  4. Avoid facing directly to the movable sliding door from next hangar (side-wall setting recommended)
  5. Plug in the charger to AC outlet (all the time)
  6. Close the hangar door; arm the system by pressing the key fob before leaving
  7. One "beep" sound should be heard if the system is armed then after 1 to 5 minutes delay time the system are working properly
  8. Disarm the system by pressing the key fob before opening the hangar door
  9. Double "beep, beep" sound should be heard if the system is disarmed properly
  10. For larger size hangar, upgrade PIR detector 80'x80' or 15'x200', call 1-888-452-898
 		 
 

Fig 1
 

Fig 2

 
 

CARRY-OUT COCKPIT PROTECTION: (Fig. 3)

  1. Unplug the charger from the AC outlet, carry with you for the trip (the inside battery can be back up for 40hrs)
  2. After arriving your destination, set the system either inside the rear spot or front spot of the aircraft for covering the whole fuselage
  3. Close door and windows of aircraft before arming the system
  4. If solar charger (EE777 SBC) available, plug in the charger and place the solar charger plate in proper spot for energy receiving (top of the dash board recommended)
  5. Disarm the system before opening the door to entry

Note: DO NOT arm the system during flight
 

Fig 3

 
 
NAVGUARD/EE777A LIMITED WARRANTY

E&E Electronic Engineering Research Inc. provides the first-year (12 months) product limited warranty and can be extended after the first-year (12 months), based on customer’s request extended coverage available for additional $10.00 per month. Warranty covers the free of defects in materials and workmanship under normal usage and service. Damages caused by acts of nature and/or gods are excluded from this warranty and are not covered. Warranty service is nontransferable and applies only to the original customer purchaser. Warranty does not apply where damage or component failure is due to misuse, tampering, improper installation, unauthorized alternation of the product, and/or if the product has been serviced or repaired by anyone other than E&E Electronic Engineering Research Inc. unless certified as authorized by E&E Electronic Engineering Research Inc. Applicability of warranty service shall be as determined by E&E Electronic Engineering Research Inc.

This warranty contains the entire warranty. E&E electronic Engineering Research Inc. neither assumes, nor authorized any other person purporting to act on its behalf to modify or to change this warranty, or to assume for it any other warranty or liability concerning this product. In no event shall E&E Electronic Engineering Research Inc. be liable for any direct, indirect or consequential damages, loss of anticipated profits, loss of time or any other losses incurred by the buyer in connection with the purchase, installation or operation or failure of this product.

* Note:
 NAVGUARD/EE777A is designed to enhance security/safety, operation and function. It is not a life saving device. Installers and users should follow the installation, setup, maintenance and test procedures described in the manual, local code and regulations. NAVGUARD/EE777A is not intended to provide additional protection and/or any other functions not described by E&E Electronic Engineering Research Inc.